Abstract
With the Environmental Protection Agency (EPA) regulating the amount of NOx, Particulate, HC and CO at all driving conditions, emission standards for diesel engines are becoming more stringent than ever. To meet future emission regulations, researchers have proposed two solutions based on injection control, the common-rail type injection system, and the unit injection system. Most researchers agree that the electronically controlled unit injector, which realizes high injection pressure and precise control of SOI (Start Of Injection) and injection quantity, has an advantage in meeting future emission regulations. In order to control the start and end of injection, each unit injector contains a time-controlled high speed solenoid valve. Thus, the fuel injection quantity is determined by the time interval between closing and opening of the solenoid valve. This study introduces a method for the design of the solenoid which is installed in the unit injector. It is shown that there are certain significant parameters to be optimized to improve solenoid performance: inductance, stroke, input voltage, coil resistance, load and switching time.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
