Abstract
A preliminary study of the behavior of ultrasonic guided wave mode in a pipe using a comb transducer for maintenance inspection of power plant facilities has been verified experimentally. Guided wave mode identification is carried out in a pipe using time-frequency analysis methods such as wavelet transform (WT) and short time Fourier transform (STFT), compared with theoretically calculated group velocity dispersion curves for longitudinal and flexural mode. The results are in good agreement with analytical predictions and show the effectiveness of using the time-frequency analysis method to identify the individual guided wave modes. And, It was found out that longitudinal mode (0, 1) is affected by mode conversion less than the other modes. Therefore, L (0, 1) is selected as a optimal mode for evaluating location of the surface defect in a pipe.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
