Abstract
Ammonia is gaining more interest as a carbon-free alternative fuel in freight transportation applications, especially the shipping industry. However, the problems of nitrous oxide (N2O) emissions, which has almost 300 times higher global warming impact than carbon dioxide (CO2), and ammonia slip have been the main challenges of using ammonia in compression ignition (CI) diesel engines. In this study, the effect of split diesel injection strategy (i.e., two-pulse diesel injection) on an ammonia/diesel dual-fuel (ADDF) engine is investigated under medium load operating conditions. Results indicate that the ADDF combustion mode with single diesel injection strategy achieves lower indicated thermal efficiency (ITE) compared to the corresponding diesel-only combustion mode. However, the use of split diesel injection strategy increases the ITE of the ADDF combustion mode to 39.72% which is higher than that obtained by diesel-only combustion mode (maximum ITEdiesel = 38.62%). Moreover, split diesel injection strategy reduces the unburned ammonia emissions of the ADDF combustion mode by up to 83.5% compared to the lowest unburned ammonia emissions achieved by single diesel injection strategy. Two split diesel injection strategies based on the optimum points of greenhouse gas (GHG) emissions are suggested in this research. At the first optimum point, the GHG emissions of the ADDF combustion mode are decreased by 23.7%, while ITE is increased by about 2% compared to the optimum point of diesel-only combustion mode. This, however, comes with about 10% higher nitrogen oxides (NOx) emissions. The emitted GHG emissions of ADDF combustion can be further reduced by 30.6%, but at the expense of 2.2% lower ITE and 52.4% higher NOx emissions than diesel-only combustion mode. At both optimum points, unburned ammonia emissions were significantly reduced to below 900 ppm compared to that of ADDF combustion mode with single diesel injection strategy (i.e., 4445 ppm). The lowest unburned ammonia concentration achieved in this study is still above the recommended exposure limit and therefore the use of appropriate after-treatment devices should be considered in the future.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.