Abstract
A Ti–6Al–4V alloy wall with 80 vol.% equiaxed prior-β grains was fabricated via wire and arc additive manufacturing. However, the equiaxed prior-β grains were characterized by strong texture. Formation mechanisms of the equiaxed prior-β grains were discussed. The tensile results presented a much lower anisotropy than that in other studies.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.