Abstract
In electrical discharge machining (EDM) powder material can be mixed into the dielectric fluid to improve quality of machining surface of components. Therefore, finding suitable input parameters of this process becomes an important task. This paper presents a methodology to find the optimum input factors of the EDM process when adding nanosilicon carbide powder into the dielectric fluid for processing cylindrical shaped parts. In this research, the Taguchi method was used for experiment design in order to investigate the effect of the input parameters on the surface roughness. Also, optimum input factors for minimum surface roughness (RS) was proposed. The result from the deviation of SRbetween the analysis and the experiment demonstrates that the optimum input parameters are helpful to predict the value of surface roughness. Therefore, this can increase the economic and technical effectiveness in EDM process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
