Abstract
A one directional acoustic emission (AE) source characterization has been used during a three point bending fracture toughness test on 6061 aluminum matrix composites with Al 2O 3 particle reinforcements of 5 and 10 μm sizes, in order to evaluate the dynamic process of micro-fracture in these materials. Different acoustic emission sources are characterized and, as a result, two types of AE events are distinguished. It is observed that at very low strain levels void nucleation is the main source for acoustic emission. At higher levels, the micro pop-in of primary voids and their eventual coalescence results in a different type of acoustic emission. In fine particle reinforced materials, when the amplitude of AE events in void nucleation at fine particles is not high enough to be detected, the main source of AE events is only the void coalescence. By increasing the particle size, the number of detectable events during void nucleation is increased.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
