Abstract
This paper presents the development of a new Copper-ABS feedstock material by the injection molding machine. The material consists of copper powder filled in an acrylonitrile butadiene styrene (ABS) binder and surfactant material. In this study, the effect of metal filled ABS and binder content on the contact angle and surface tension was investigated experimentally. The detailed formulations of compounding ratio with various combinations of a new Copper-ABS feedstock was done by volume percentage (vol. %). Based on the result obtained, an increment by vol. % of copper filler in ABS effected on contact angle and surface tension results. With highly filled copper content in ABS composites increase the surface tension value. It can be observed that, the tendency of the liquid surface that allow to resist an external force in PMC material through an injection molding process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
