Abstract
The magnetic camera using magnetic lens is proposed to satisfy the demands such as obtaining the distribution of the magnetic flux leakage (DMFL) on the high lift-off, and improving sensitivity. However, DMFL is strongly affected by the magnetization direction. Therefore, the DMFL has low intensity when the crack is not perpendicular to the magnetizing direction. Also, quantitative nondestructive evaluation would be difficult. This paper proposes an improved magnetization method to evaluate a crack quantitatively, regardless of the crack direction. The secondary magnetic source, which is perpendicular to the primary magnetic source, is introduced in the scan type magnetic camera. The intensity of two values of ∂B/∂x (1st differential to the magnetization direction) of the DMFL can be used to evaluate the crack volume. The experimental and the numerical analysis results are considered to verify this phenomenon.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.