A study of the free vibration of flexible-link flexible-joint manipulators

Abstract

In this article, explicit expressions for the frequency equation, mode shapes, and orthogonality of the mode shapes of a Single Flexible-link Flexible-joint manipulator (SFF) are presented. These explicit expressions are derived in terms of non-dimensional parameters which make them suitable for a sensitivity study; sensitivity study addresses the degree of dependence of the system’s characteristics to each of the parameters. The SFF carries a payload which has both mass and mass moment of inertia. Hence, the closed-form expressions incorporate the effect of payload mass and its mass moment of inertia, that is, the payload mass and its size. To check the accuracy of the derived analytical expressions, the results from these analytical expressions were compared with those obtained from the finite element method. These comparisons showed excellent agreement. By using the closed-form frequency equation presented in this article, a study on the changes in the natural frequencies due to the changes in the joint stiffness is performed. An upper limit for the joint stiffness of a SFF is established such that for the joint stiffness above this limit, the natural frequencies of a SFF are very close to those of its flexible-link rigid-joint counterpart. Therefore, the value of this limit can be used to distinguish a SFF from its flexible-link rigid-joint manipulator counterpart. The findings presented in this article enhance the accuracy and time-efficiency of the dynamic modeling of flexible-link flexible-joint manipulators. These findings also improve the performance of model-based controllers, as the more accurate the dynamic model, the better the performance of the model-based controllers.