Abstract
The behaviour of shock wave inside a shaped charge is so important that the detonation wave nature characterizes (determines) the degree of jet coherency at the liner interface. The detonation wave shape inside the shaped charge depends on the casing thickness, material, the liner material, geometry and the applied wave shaper geometry. In this paper, a series of numerical simulation models were performed to study the incident and reflected waves and to characterize the resulting shock wave front to evaluate its effect on the produced (generated) jet characteristics. The used code was Autodyn 3D based on non-linear dynamic analysis with jetting analysis model. Inert wave shapers (Lead, Aluminium and steel) and active ones (TNT and PETN) behaviour were studied. The liner type used in this study was copper with in which the apex angle of the liner cone was 40°. It was concluded that the wave front shape has an obvious influence on the characteristics of the jet formation and its properties such as mass of jet and velocities of its tip. Also, the bulk sound speed of the liner itself in addition to the collapse characteristics of the liner was discussed in this paper successfully.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
