A study of the atmospheric surface layer and roughness lengths on the high‐altitude tropical Zongo glacier, Bolivia

Abstract

AbstractThe atmospheric surface layer of high‐altitude tropical glaciers is inadequately understood, particularly concerning turbulent fluxes. Measurements have shown that sublimation reduces melt energy in the dry season, but the errors are large when a katabatic wind maximum occurs at a low height. This study analyzed wind and temperature vertical profiles measured by a 6 m mast in the ablation area of the tropical Zongo glacier (16°S, 5060 m above sea level) in the dry seasons of 2005 and 2007. Surface roughness lengths for momentum and temperature were derived from least squares fits of hourly wind and temperature profile data. Measurement errors were explored, focusing on the poorly defined reference level for sensor heights. A katabatic wind maximum at heights between 2 and 3 m was regularly observed during low wind speed and strong inversion conditions, or about ~50%of the time, greatly reducing the surface layer depth. The glacier surface, experiencing melting conditions in the early afternoon and strong cooling at night, remained relatively smooth with z0 ~ 1 mm and zT ~ 0.1 mm. Sensible heat flux measured at ~1 m was not very sensitive to the zero reference level due to two opposite effects: when measurement heights increase, profile‐derived roughness lengths increase but temperature and wind gradients decrease. The relation between zT/z0 and the roughness Reynolds number Re* roughly agrees with the surface renewal model. However, this is mostly due to self‐correlation because of the shared variable z0 in zT/z0 and Re*, which prevents a sound experimental validation of the model.