Abstract
The aim of this work is to develop a study of Taguchi optimization method for low surface roughness value in terms of cutting parameters when face milling of the cobalt-based alloy (stellite 6) material. The milling parameters evaluated are feed rate, cutting speed and depth of cut, a series of milling experiments are performed to measure the surface roughness data. The settings of face milling parameters were determined by using Taguchi experimental design method. Orthogonal arrays of Taguchi, the signal-to-noise (S/N) ratio, the analysis of variance (ANOVA) are employed to find the optimal levels and to analyze the effect of the milling parameters on surface roughness. Confirmation tests with the optimal levels of cutting parameters are carried out in order to illustrate the effectiveness of Taguchi optimization method. It is thus shown that the Taguchi method is very suitable to solve the surface quality problem occurring the face milling of stellite 6 material.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
