Abstract
The Initial Graphics Exchange Specification has become the most widely accepted means of transferring data between dissimilar CADCAM systems. This article reports the results obtained from a study of IGES Version 2.0 transfers between two commercial two-dimensional systems. A large number of test files were created and transferred, and by progressively modifying each file the boundaries of successful transfer were explored. The study showed that while data can be transferred there are some limitations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
