Abstract
Density functional calculations with accurate quadrature and large basis sets are reported on ozone, thiozone, methylene, and the beryllium dimer. The Kohn–Sham self-consistent procedure is used throughout and nonlocal gradient corrected functionals (B-LYP, B-P) are used. The systems and properties chosen are notoriously difficult problems for accurate computation, nevertheless, the density functional methods perform well. It is found, in line with calculations on more straightforward problems, that the functionals involving gradient corrections are more reliable than local density functionals. The B-LYP prediction is within 5 kcal/mol of the most accurate ab initio data on the C2v–D3h energy gap in ozone and thiozone. The B-LYP functional performs reasonably well on the vibrational frequencies of ozone whilst the B-P functional gives very accurate results for the structural parameters of ozone. B-LYP is used to estimate the singlet–triplet splitting in methylene with the triplet treated in both a restricted and unrestricted formalism. In either case the correct energy gap is reproduced within 2 kcal/mol. The bond length and low frequency of the beryllium dimer are reproduced accurately by the gradient corrected functionals but the binding energy is overestimated. However, B-LYP only overestimates the binding energy by 4 kcal/mol, which is an encouraging result given the difficulty of the problem. This paper can therefore be seen as further evidence that density functionals methods, and in particular methods based on nonlocal functionals, can predict molecular properties reasonably accurately for systems that have multireference character.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have