Abstract
A burr formation process in micro-cutting of Al7075-T7451 was analyzed. Three stages of burr formation including steady-state cutting stage, pivoting stage, and burr formation stage are investigated. And the effects of uncut chip thickness, cutting speed and tool edge radius on the burr formation are studied. The simulation results show that the generation of negative shear zone is one of the prime reasons for burr formation. Uncut chip thickness has a significant effect on burr height; however, the cutting speed effect is minor. Unlike in conventional cutting, in micro-cutting the effect of tool edge radius on the burr geometry can no longer be neglected.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
