A Study of Dry Etching Process for Sigma-Shaped Si Recess

Abstract

The fabrication of sigma-shaped silicon recess normally consists of dry etch process to shape the silicon trench and post etch treatment to form the sigma-shaped cavity within bulk silicon substrate. Here we are dedicated to the optimization of silicon recess dry etch process and its effect on the final sigma-shaped SiGe physical performance. Results show the isotropic ratio of horizontal over vertical direction could be doubled. This caters much larger process window for the desired strain introduction at the hetero-junction of SiGe/Si. Besides, the corresponding dry etching solutions are also disclosed from the point of view of tip depth adjustment and tip horizontal pull-back control. Both physical indexes could be independently controlled to deliver the required sigma-shaped Si recess trench.