Abstract

A finite element model of orthogonal metal cutting including burr formation is presented. A metal-cutting simulation procedure based on a ductile failure criterion is proposed for the purpose of better understanding the burr formation mechanism and obtaining a quantitative analysis of burrs using the finite element method. In this study, the four stages of burr formation, i.e., initiation, initial development, pivoting point, and final development stages, are investigated based on the stress and strain contours with the progressive change of geometry at the edge of the workpiece. Also, the characteristics of thick and thin burrs are clarified along with the negative deformation zone formed in front of the tool edge in the final development stage. [S0094-4289(00)00702-7]

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.