Abstract
This paper aims to investigate the electromigration phenomenon of under-bump-metallization (UBM) and solder bumps of a flip-chip package under high temperature operation life test (HTOL). UBM is a thin film Al/Ni(V)/Cu metal stack of 1.5 μm; while bump material consists of Sn/37Pb, Sn/90Pb, and Sn/95Pb solder. Current densities of 2500 and 5000 A/cm 2 and ambient temperatures of 150–160 °C are applied to study their impact on electromigration. It is observed that bump temperature has more significant influence than current density does to bump failures. Owing to its higher melting point characteristics and less content of Sn phase, Sn/95Pb solder bumps are observed to have 13-fold improvement in Mean-Time-To-Failure (MTTF) than that of eutectic Sn/37Pb. Individual bump resistance history is calculated to evaluate UBM/bump degradation. The measured resistance increase is from bumps with electrical current flowing upward into UBM/bump interface (cathode), while bumps having opposite current polarity cause only minor resistance change. The identified failure sites and modes from aforementioned high resistance bumps reveal structural damages at the region of UBM and UBM/bump interface in forms of solder cracking or delamination. Effects of current polarity and crowding are key factors to observed electromigration behavior of flip-chip packages.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
