Abstract
Microstructure characterization is of great value to understanding nuclear graphite's properties and irradiation behavior. However, graphite is soft and could be easily damaged during sample preparation. A three‐step polishing method involving mechanical polishing, ion milling, and rapid oxidation is proposed for graphite. Ion milling is adopted to remove the broken graphite pieces produced by mechanical polishing. Rapid oxidation is then adopted to remove irradiation‐induced damage layer during ion milling. The Raman spectra show very small G peak width and very low ID/IG ratio after rapid oxidation. The microcracks that were conventionally observed via a transmission electron microscope can be observed on rapid‐oxidized surface in a scanning electron microscope. By digital image processing, the microcracks along with the gas‐escape pores in nuclear graphite IG‐110 are statistically analyzed. Porosity's distributions on crack (pore) size (spanning from 10 nm to 100 μm) are given, which could help to understand and simulate graphite's performances in reactors.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
