Abstract
In a reverberation chamber, the stirring efficiency of the source stir technique is very high. However, to apply the source stir, the configuration (position, orientation, or polarization) of the transmitting (Tx) antenna has to be changed every time in the stirring process. To solve this problem, we use a three-dimensional printed robotic arm to control the position and orientation of the Tx antenna; thus, the source stirring process can be performed automatically. The measurement results are validated and compared with that from mechanical stirrers. Figures of merit such as autocorrelation, average K -factor, and total scattering cross-section are presented. The statistical distribution is also verified by using Kolmogorov–Smirnov test. Results show that the source stir technique outperforms the mechanical stirring technique significantly.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Electromagnetic Compatibility
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
