Abstract
Introduction. It is necessary to improve methods of analysis of the limit states, occurring when a thin-walled shell is in the elastoplastic domain, to use these cylindrical shells as elements of heavily loaded products of construction and machine building industries. Materials and methods. The problem of stability of a circular thin-walled cylindrical shell, made of steel 45 GOST 1050-2013, that takes the load induced by pure compression and axial torsion, has been studied. Besides, experimental and theoretical components of the problem have been analyzed. Experimental facility SN-EVM was applied to perform an experiment test and analyze its findings in terms of different versions of the theory of plasticity used to solve shell stability problems beyond the elastic limit. The co-authors emphasize the unavailability of any definition of the criterion of stability loss under combined loading based on experimental dependences that were identified earlier. The results of the experiment were compared with the results of the theoretical study. The analysis of the shell stability in the case of complex subcritical loading are based on the A.A. Ilyushin theory of stability, in which plasticity functions are taken according to V.G. Zubchaninov’s approximations. Results. The problem was solved using the software programme, developed by the co-authors. The software solves the bifurcation problem of a cylindrical shell with regard for the complex nature of deformations at the moment of stability loss in the case of exposure to complex subcritical loading, commensurable processes and the trajectory that has the form of circular arcs. It has been shown that the proposed method of analysis and approximations describe the real stress-strain state of shells that feature low flexibility in respect of a complex pattern of deformation and characterize a stable state of the material beyond the elastic limit. Conclusions. The theoretical strength and deformability analysis of a cylindrical shell and its experimental studies demonstrate sufficient convergence which proves their reliability. This conclusion will allow to improve the process of design of structural elements made of materials that have complex mechanical properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.