A single-step method for synthesis of CuInS2 nanostructures using cyclic microwave irradiation

Abstract

Pure and well-crystalline CuInS2 nanostructures were successfully synthesized via a cyclic microwave irradiation method at low microwave power using cupric chloride dihydrate (CuCl2·2H2O), indium chloride tetrahydrate (InCl3·4H2O) and thioacetamide as starting reagents. The effects of processing cycles (2–75 cycles) and microwave heating powers (180–600W) on purity, crystallinity, particle size and morphology of the synthesized products were investigated. The synthesized products were characterized by X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM), transmission electron microscopy (TEM) and UV–vis spectroscopy. Increasing processing cycles and microwave heating power improved the purity and crystallinity of the synthesized products. Using the microwave powers of 450 and 600W with 75 cycles, pure CuInS2 nanocrystallites were obtained. The CuInS2 crystallites displayed nanoparticles in clusters with decreasing in the diameter sizes from 1.6 to 0.9µm when the microwave power was increased from 180 to 600W. The reaction mechanism of the CuInS2 formation was also provided. A CuInS2 solar cell, made from FTO/TiO2/CuInS2/CdS/Pt-FTO layers, was fabricated to explore the potential use of the CuInS2 nanoparticles in photovoltaic devices. The photovoltaic properties of the CuInS2 solar cell including open-circuit voltage (Voc), short-circuit current density (Jsc) and fill factor (FF) were 281.10mV, 0.072mA/cm2 and 0.47, respectively, with cell conversion efficiency (η) of 0.01% under 1.5 AM illumination.