Abstract
A single-roll thin-strip casting process has been described and the effect of operating parameters on the strip quality experimentally studied concerning mainly casting speed and nozzle location angle. As a result, an optimum operating condition has been established which shows that the nozzle location angle is an important factor. A large nozzle location angle tends to lead to strip jamming, whereas a small angle gives rise to production of narrow strips with poor surface quality.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
