Abstract

A single leg bending test is described and its suitability for interfacial fracture toughness testing is evaluated. The test specimen consists of a beam-type geometry comprised of two materials, one ‘top’ and one ‘bottom’, with a split at one end along the bimaterial interface. A portion of the bottom material in the cracked section of the beam is removed and the geometry is loaded in three-point bending. Thus, the reaction force of the support at the cracked end is transmitted only into the material comprising the top portion of the beam. The test is analyzed by a crack tip element analysis and the resulting expressions for energy release rate and mode mixity are verified by comparison with finite element results. It is shown that, by varying the thicknesses of the two materials, the single leg bending test can be used to determine the fracture toughness of most bimaterial interfaces over a reasonably wide range of mode mixities.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.