Abstract
The procedure described for survey and design of diagnostic casts is applicable to either dental arch. It is presented in a sequential manner, is not complex, and will produce uniformly acceptable results. The following steps should be followed: (1) locate a path by tilting the cast; (2) mark the survey lines and tripod the cast; (3) outline the rests and guide planes; (4) draw minor connectors; (5) draw major connectors; (6) draw retention mesh for acrylic resin; (7) draw acrylic resin base extension; and (8) draw direct retainers (clasps).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
