A Simple MicroThermal Desorption Device

Abstract

A new method for thermal desorption of small samples is presented. The method uses a solid phase microextraction (SPME) holder with the fiber removed. The sample-for example, an ink sample on paper-is simply placed inside the needle of the holder, where normally an SPME fiber is positioned. The thermal desorption is then performed on any kind of gas chromatograph in a manner similar to that for SPME analysis. The needle of the SPME holder penetrates the injector septum; the temperature of the thermal desorption is simply the temperature of the injector. No solvents or liquid nitrogen cooling are used. The paper sample is kept inside the holder needle during the analysis. After the analysis is completed, the sample is removed from the needle by pushing forward the steel wire inside the needle in the way normally used to perform sampling with the SPME fiber. The desorbed compounds were analyzed by gas chromatography with a flame ionization detector or by gas chromatography-mass spectrometry. The optimum temperature for desorption of ink samples on paper was 200 degrees C. The influence of the paper matrix is negligible at that temperature. Laboratories lacking the commercial device for thermal desorption can use this cheap device for the analysis of, for example, writing ink, printing ink, and inkjet ink samples on paper. Other types of samples can be investigated but the size of samples suitable for analysis is limited.