Abstract

The standard characteristic polynomial is an effective, simple and intuitional way for the design of multi-loop control systems to reduce the calculation loads. This method in this paper is proposed in order to calculate the initial value of the parameters for control system. The initial value of the multi-loop control parameters are calculated according to the different route parameters, and several types route controller parameters are calculated in off-line processing. NCD (Nonlinear Control Design) optimal method based on standard characteristic polynomial is used to optimize the parameters of the control system. Simulation results show the optimality improvement by the method. Furthermore , robustness of control system designed is better.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.