A simple failure criterion for rough joints and compound shear surfaces

Abstract

The subject under investigation is the strength of a single shear plane which exhibits a regular, asymmetric roughness pattern. In the shear direction the asperities are so steeply inclined that the joint becomes mechanically non-effective with the result that the asperities are sheared off. Against the shear direction the asperities are only gently inclined. It is shown that this particular roughness pattern is of some general importance in geomechanics (examples: unconfined compression test; shear plane with secondary fractures). Simple analytical considerations allow the formulation of a shear criterion, which is dependent on friction angle ø m and cohesion c m of the intact rock and on the inclination γ of the gently inclined parts of the asperities which are dipping against the shear direction. In the Mohr-diagram the criterion results in envelopes which converge at high normal stresses against the envelope of intact rock. Furthermore, the criterion expresses that both the slope of the envelopes and the dilation angle continuously decrease with increasing normal stress. Therefore the criterion adequately describes features which are regarded as most important when shearing rough joints or compound shear surfaces.