Abstract

In Pearl Harbor, where there often were eight hundred ships of all kinds, the underwater noise level was high. No place was found where noise measurements could be made satisfactorily, and therefore it was decided that the best arrangement would be to insulate Auxiliary Repair Docks, and measure the noise of submarines while they were in the docks. This was done by the development of a suitable air bubble screen across the open end of the dock. Such an acoustic barrier was comparatively easy to install, did not interfere with submarines entering and leaving, kept ocean surface oil out of the dock, insulated against low as well as high frequency noises as was required, and, after extensive experimentation, the noise of the screen was reduced to a level that did not interfere with the noise measurements. The insulation of the screen upon the noise of a nearby submarine charging batteries is illustrated by a phonograph recording.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.