A robust electrochemical sensor based on N,S-FeNi3/C for simultaneous detection of hydroquinone and arbutin in cosmetics.

Abstract

Forpractical analysis and simultaneous detection of arbutin (AR) and hydrochinone (HQ)in cosmetics, an electrochemical sensor has been designedbased on nitrogen and sulfur co-doped Fe-Ni alloy (N,S-FeNi3/C) nanoparticles. The N,S-FeNi3/C has beenprepared for the first time via hydrothermal synthesis and high-temperature carbonization. N,S-FeNi3/C not only improves the charge transfer to the surface, but also provides rich active sites and fast ion diffusion rates owing to the iron and nickel bimetallic materials. In addition, the d-band structure of transition metals (nickel and iron) introduced by the N and S atoms exhibits an electronic structure similar to that of noble metal catalysts, thus enhancing electrocatalytic activity and increasing conductivity. Additionally, the double doping of S and N atoms significantly increases the active sites of carbon atoms; thus, N-S-FeNi3/C exhibits excellent electrochemical catalytic activity for the oxidation of AR and HQ. Further, theN,S-FeNi3/C sensor is used for the simultaneous determination of HQ and AR by square-wave pulse voltammetry. Distinct oxidation peaks of HQ and AR are observed at potentials of +0.028 V and +0.352 V (vs. SCE). The electrical signal increases linearly in the HQ concentration ranges of 0.1-100 μM and 0.05-70 μM for the simultaneous determination of AR and HQ with a detection limit as low as 0.0476 and 0.0135 μM (S/N = 3), respectively. Thus, rapid and accurate detection of AR and HQ in spiked cosmetics is successfully achieved, with a recovery ranging from 96.4 to 104.2%, and the relative standard deviation is lower than 3.8-4.0%.