Abstract

Low-frequency oscillations in power systems can be modeled as an exponentially damped sinusoid (EDS) signal. Its frequency, damping factor, and amplitude are identified by the robust algorithm proposed in this paper. Under the condition of no noise, the exponentially convergent property of the proposed identification is proved by the use of time scale change, variable transformation, slow integral manifold, averaging method, and Lyapunov stability theorem in sequence. Under the condition of bounded additive noise, the antinoise performance of the identification of each parameter is investigated by the perturbed system theorem and error synthesis principle. The robustness of the proposed method is embodied in the following aspects: the exponential convergence for EDS signal with a wide range of frequency, especially with a rather low frequency; the boundary values of identification errors resulting from high-frequency sinusoidal noise of both frequency and damping factor can be adjusted by tuning the design parameters; and the different effects of the four design parameters on tracking performance and antinoise performance of each parameter identification. Simulation results demonstrate the performance of the algorithm and validate the conclusions.

Highlights

  • Widespread used renewable and sustainable energy sources bring modern power systems electromechanical oscillations, synchronous, and subsynchronous oscillations [1,2,3,4,5,6]

  • Because the oscillating frequency is much lower than the fundamental frequency of power systems, 50 Hz or 60 Hz, the low-frequency oscillations (LFO) in power systems are extracted from the measured voltage signals or current signals by low-pass filters

  • A robust algorithm is proposed for asymptotically identifying the frequency, the damping factor, and the amplitude of a LFO modeled as an exponentially damped sinusoidal signal

Read more

Summary

Introduction

Widespread used renewable and sustainable energy sources bring modern power systems electromechanical oscillations, synchronous, and subsynchronous oscillations [1,2,3,4,5,6]. The low-frequency oscillations (LFO) may result in unstable and unsecure operation of power systems, so the real-time identification of frequency, amplitude, and damping factor are still essential in recent years [7,8,9,10]. In a transient state of power systems, the electromechanical oscillations usually have amplitudes decaying as time and low oscillating frequency in range of 0.05-2.0 Hz [9, 10]. The LFO can be modelled as low frequency exponentially damped sinusoid (EDS) signal. The key technique to identify the parameters of LFOs is the parameter identification of one exponentially damped lowfrequency sinusoid

Methods
Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.