Abstract
Generators working with variable speed, rather than fixed speed, have many advantages, which are well documented in the literature. Higher efficiency, better power to size ratio and less mechanical stress in the system are some of the characteristics of variable speed generators. In particular, variable speed diesel generators can be used to provide small highly portable generation systems for emergency vehicles and military/aerospace applications. Such systems can be used to feed stand-alone linear/non-linear loads if an adequate power converter interface is provided. Four-leg matrix converters can be used as the power electronic interface between variable speed generators and stand-alone loads. The fourth leg provides a neutral point for single phase loads and a path for the circulation of zero sequence currents. When non-linear loads are connected to the matrix converter output, relatively high harmonic distortion can be produced in the load voltage unless an appropriate control system is provided. In this paper the application of a repetitive control system to improve the quality of the load voltage is presented. Experimental results obtained from a prototype are shown and fully analysed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.