Abstract

Non-aqueous Li-air batteries have been intensively studied in the past few years for their theoretically super-high energy density. However, they cannot operate properly in real air because they contain highly unstable and volatile electrolytes. Here, we report the fabrication of solid-state Li-air batteries using garnet (i.e., Li6.4La3Zr1.4Ta0.6O12, LLZTO) ceramic disks with high density and ionic conductivity as the electrolytes and composite cathodes consisting of garnet powder, Li salts (LiTFSI) and active carbon. These batteries run in real air based on the formation and decomposition at least partially of Li2CO3. Batteries with LiTFSI mixed with polyimide (PI:LiTFSI) as a binder show rechargeability at 200 °C with a specific capacity of 2184 mAh g−1carbon at 20 μA cm−2. Replacement of PI:LiTFSI with LiTFSI dissolved in polypropylene carbonate (PPC:LiTFSI) reduces interfacial resistance, and the resulting batteries show a greatly increased discharge capacity of approximately 20300 mAh g−1carbon and cycle 50 times while maintaining a cutoff capacity of 1000 mAh g−1carbon at 20 μA cm−2 and 80 °C. These results demonstrate that the use of LLZTO ceramic electrolytes enables operation of the Li-air battery in real air at medium temperatures, leading to a novel type of Li-air fuel cell battery for energy storage.

Highlights

  • A new class of solid-state electrolytes, garnet-type Li7La3Zr2O12 (LLZO) ceramics, were first reported by Murugan et al.[29] in 2007

  • A Li foil is attached on the LLZTO, which is sealed in a stainless steel container with high-temperature resistive sealant

  • A novel type of solid-state Li-air battery based on LLZTO ceramic electrolytes is demonstrated here

Read more

Summary

Introduction

A new class of solid-state electrolytes, garnet-type Li7La3Zr2O12 (LLZO) ceramics, were first reported by Murugan et al.[29] in 2007. Based on these LLZTO disk electrolytes (~0.1 cm in thickness), we designed a new type of SSLAB architecture. These two-part SSLABs can be operated in real air with good rechargeability. By replacing PI:LiTFSI with PPC:LiTFSI as the conductive binder, the batteries can be operated at reduced temperatures while displaying improved performance

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call