A quasi-two-dimensional fluid experimental apparatus based on tank-in-tank configuration.

Abstract

Listen

Translate article

The fluid tank is an essential facility for experimental research on fluid mechanics. However, owing to the hydrostatic fluid pressure, a fine uniformity of the narrow channel is difficult to be maintained in a tall narrow-channel tank. To address this issue, we proposed a quasi-two-dimensional fluid experimental apparatus based on a "tank-in-tank" configuration and built with an outer tank and an inner tank. The outer tank was cuboid-shaped and used to load the fluid medium, while the inner tank, consisting of two parallel glass plates, was embedded into the outer tank and served as the experimental channel. The hydrostatic pressure acting on the channel was balanced so that a high level of uniformity was maintained over the whole channel. The available height and width of the channel were 2800 and 1500mm, respectively, while its gap distance could be adaptive from 0 to 120mm. Experimental research on motion characteristics of circular disks falling in the quasi-2D channel was implemented to investigate the effects of the falling environment and disk geometry. Four distinct falling types were observed, and the wake flow fields of the falling disks were visualized. The Reynolds numbers of falling disks ranged from 400 to 63 000 presently. Chaotic motion and regular motion were demarcated at Re ≈ 30 000. An analytical model was established to predict the final average falling velocity and Reynolds number. Finally, potential directions for future research and improvements to the apparatus were suggested.