Abstract
A fully-integrated power management ASIC for efficient inductive power transmission has been presented capable of automatic load transformation using a method, called Q-modulation. Q-modulation is an adaptive scheme that offers load matching against a wide range of loading (RL ) and coupling distance (d23 ) variations in inductive links to maintain high power transfer efficiency (PTE). It is suitable for inductive powering implantable microelectronic devices (IMDs), recharging mobile electronics, and electric vehicles. In Q-modulation, the zero-crossings of the induced current in the receiver (Rx) LC-tank are detected and a low-loss switch chops the Rx LC-tank for part of the power carrier cycle to form a high-Q LC-tank and store the maximum energy, which is then transferred to RL by opening the switch. By adjusting the duty cycle (D), the loaded-Q of the Rx LC-tank can be dynamically modulated to compensate for variations in RL . A Q-modulation power management (QMPM) prototype chip was fabricated in a 0.35-μm standard CMOS process, occupying 4.8 mm2. In a 1.45 W wireless power transfer setup, using a class-E power amplifier (PA) operating at 2 MHz, the QMPM successfully increased the inductive link PTE and the overall power efficiency by 98.5% and 120.7% at d23 = 8 cm, respectively, by compensating for 150 Ω variation in RL at D = 45%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
