Abstract
Abstract This research is the first attempt to study the possibility of employing magnetic water (MW), Zamzam water (ZW) and seawater (SW) as mixing water for alkali-activated slag (AAS) pastes. The results of workability, pH value, compressive strength and microstructure of different specimens mixed with each type of water were compared with those mixed with tap water (TW). The X-ray diffraction (XRD), thermogravimetric analysis (TGA) and scanning electron microscopy (SEM) were used to analyze the results. The results showed that using MW, ZW or SW increased the workability, pH value and compressive strength of AAS pastes. The microstructures of the samples prepared with these water types were modified as confirmed by SEM, whilst the polymerization processes were accelerated as confirmed by TGA. It was found that MW has the height improvement followed by ZW and SW, respectively, whilst TW came in the last place.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.