Abstract
Electroencephalogram (EEG) electrodes are critical devices for brain-computer interface and neurofeedback. A pre-gelled (PreG) electrode was developed in this paper for EEG signal acquisition with a short installation time and good comfort. A hydrogel probe was placed in advance on the Ag/AgCl electrode before wearing the EEG headband instead of a time-consuming gel injection after wearing the headband. The impedance characteristics were compared between the PreG electrode and the wet electrode. The PreG electrode and the wet electrode performed the Brain-Computer Interface (BCI) application experiment to evaluate their performance. The average impedance of the PreG electrode can be decreased to 43 [Formula: see text] or even lower, which is higher than the wet electrode with an impedance of 8 [Formula: see text]. However, there is no significant difference in classification accuracy and information transmission rate (ITR) between the PreG electrode and the wet electrode in a 40 target BCI system based on Steady State Visually Evoked Potential (SSVEP). This study validated the efficiency of the proposed PreG electrode in the SSVEP-based BCI. The proposed PreG electrode will be an excellent substitute for wet electrodes in an actual application with convenience and good comfort.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEE Transactions on Neural Systems and Rehabilitation Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.