Abstract
Abstract While drilling in some oil fields of the world, lost circulation may be so severe that normal remedies that might heal the loss zone are not effective. A procedure has been developed to drill "blind" or without returns. The procedure has been refined enough so that stuck drill pipe may be avoided, but the most dangerous aspect of drilling "blind" is the lack of well control. Often when circulation is lost, the well kicks and gas can flow into the wellbore due to drastic reduction in hydrostatic pressure. Furthermore, normal well control operations are ineffective. The procedure generally involves pumping a viscous slug of waterbased gel mud into the annulus and this column of mud is called a "mudcap." This approach depends on whether the lost zone is above or below a gas zone and either approach effectively limits the amount of fluid that can be used. In order to properly place a mudcap, a better understanding of the relationship between the fluid rheological properties, column height, and the initial shut-in casing pressure is required. In this respect, no quick field procedure has been developed to help rigsite personnel to control these types of wells. A set of charts have been constructed to aid field personnel in blowout prevention, when they are confronted with a gas kick occurring while drilling without returns. This situation is common in many oil fields especially in Middle East and North Africa. The set of charts is based on the slot flow approximation for Bingham fluids. Two sets of charts are developed: one for the case in which pipe is in the hole and the other when the casing is opened. Each of the charts represents a different annular configuration. These charts make life easier for rig personnel especially in a very stressful situation, and this type of pre-planning should help to avoid costly mistakes in judgment. Introduction Solutions for equations describing axial annular flow of Newtonian fluids can be determined directly. However, direct methods for solving annular flow equations for more complex rheological models, such as Bingham-Plastic and Power-Law, usually result in unwieldy expressions. To avoid this the slot flow approximation was developed. This method equates the geometry of an annulus to that of a narrow slot. Depending upon the geometric parameters used in the narrow slot approximation and the degree of accuracy required, some sort of correction for the curvature of annulus may be needed. Therefore, a suitable expression for the Newtonian curvature correction factor must be developed. Using the same correction factor as for Newtonian fluids, a slot flow approximation of the axial annular flow of Bingham-Plastic fluids should be relatively accurate. The primary purpose of this paper was to develop relations that describe the annular flow of Bingham-Plastic fluids and the pressure gradient necessary to initiate flow. With an expression that relates pressure gradient to the Bingham Plastic yield point, a set of practical charts was developed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.