Abstract
Single crystal diamond is widely used in the manufacturing of diamond cutting tools. In this work, the diamond (100) plane which is always orientated as the rake face of diamond cutting tools is polished by using a polishing pad covered with nano silica and nickel powder. The results show that the polishing with nano nickel powder can achieved the satisfactory surface quality in a defined polishing time of 140 min, in which the surface roughness of the polished diamond (100) plane reaches to 0.25 nm Ra and 2.30 nm PV in a scanning area of 50 × 50 μm2. Raman spectra analysis further reveals that graphitization or amorphization occurs on the diamond surface during polishing with nickel powder. Finally, based on the polishing method with nano nickel powder, the influence of the polishing parameters on the achieved surface quality is investigated so as to optimize the polishing parameters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.