A PLANAR, RECTANGULAR WAVEGUIDE LAUNCHER AND EXTRACTOR FOR A DUAL-MODED RF POWER DISTRIBUTION SYSTEM

Abstract

The desire to reduce the amount of low-loss, circular-waveguide delay line required in a pulse-compressing power distribution system for the Next Linear Collider has led to the pursuit of multi-moded schemes [1]. In such a system, power is delivered to different destinations through the same waveguide via different propagating modes. Current plans [2] utilize two modes, with manipulations done primarily in overmoded rectangular guide. We describe two key components of the system, a four-input/four-output, dual-mode launcher and an extractor for diverting one mode from the delay line to an accelerator feed while allowing the other to pass on to an upstream feed. These novel passive waveguide devices utilize the rectangular TE10 and TE20 modes. Because they must carry up to 600 MW pulsed rf power, H-planar symmetry is maintained in their designs to allow the use of overheight waveguide, and features that invite breakdown, such as coupling slots, irises, and septa, are avoided. Special rectangular-to-circular tapers [3] will be used to convert between the above modes and the circular TE11{sup o} (TE12{sup o}) and TE01{sup o} delay line modes, respectively. Rectangular waveguide for relative ease of handling. Mode converters, including special cross-section tapers [3] will be used to transform betweenmore » the above circular waveguide modes and the TE20 and TE10 rectangular waveguide modes, respectively.« less