Abstract
Electroosmotic (EO) micropumps use field-induced ion drag to drive liquids and achieve high pressures in a compact design with no moving parts. An analytical model applicable to planar, etched-structure micropumps has been developed. This model consists of pressure and flow relations in addition to an analytical expression that can be used to estimate the thermodynamic efficiency of planar EO pumps. The analytical model was applied to guide the design of a pump consisting of an etched EO flow chamber for near-optimal hydraulic power performance. To achieve high efficiency, the working fluid used was deionized (DI) water with a conductivity of 3.0 /spl times/ 10/sup -4/ S/m (pH = 5.7). The EO micropump was fabricated on a soda-lime glass substrate using standard microlithography and chemical wet etching techniques. The active pumping volume of the device consists of a wet-etched flow channel 1-mm long in the flow direction and 0.9 /spl mu/m by 38-mm in cross section. The pump performance agrees well with the theoretical model. The pump can produce a maximum pressure of 0.33 atm and a maximum flow rate of 15 /spl mu/L/min min at 1 kV.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.