Abstract

To determine the onset of heparin anticoagulation, using 2 different measures of activated clotting times (ACT), thromboelastography (TEG; R-time), and anti-Xa levels, after administering low- (100 U/kg) and high- (300 U/kg) dose intravenous (IV) heparin to patients undergoing transcatheter aortic valve replacement (TAVR) and cardiac surgery, respectively. Prospective study. Single academic institution. Patients with normal baseline coagulation presenting for TAVR or cardiac valve surgery. Coagulation studies were performed at baseline, 30 seconds, 90 seconds, and 180 seconds after IV heparin administration. The tests included iSTAT (iACT) and Hemochron ACT (hACT), TEG R-Time, and anti-Xa levels. At the authors' institution, anti-Xa is the preferred measure of heparin anticoagulation when time permits. ACT, a rapid point- of-care test, is used to assess intraprocedural anticoagulation. After both low- and high-dose heparin, there are peak increases in ACT and anti-Xa at 30 seconds, followed by a decline at 90 seconds and plateau at 180 seconds. The TEG R-time remained elevated (>80 minutes) throughout. For TAVR cases, all anti-Xa was >1.5 IU/mL, and was associated with an iACT >180 seconds and an hACT >200 seconds. For cardiac valve surgery cases, all anti-Xa was >2.4 and associated with an iACT >420 seconds and and hACT >340 seconds. Compared with hACT, iACTs were significantly lower at all time points after low-dose heparin, but not after high-dose heparin. In this pilot study, heparin anticoagulation was detected as early as 30 seconds after IV administration, based on ACT, anti-Xa levels, and TEG R-time.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call