A pilot‐scale demonstration of a membrane‐based absorption‐ stripping process for removal and recovery of volatile organic compounds

Abstract

AbstractA new membrane‐based continuous absorption‐stripping process has been developed to separate gas/vapor mixtures, such as volatile organic compounds (VOCs), from a nitrogen/air stream. Two different hollow fiber membrane modules are needed in this process to remove the VOCs. In the first module, VOC‐laden nitrogen/air stream flows through the bore of the hollow fibers. A suitable absorbent liquid with a high solubility for the VOC and essentially no solubility for nitrogen/air is pumped countercurrently over the outside of the fibers. This liquid is an inert, nontoxic, and essentially nonvolatile, organic solvent. The VOCs are effectively removed from nitrogen/air to a very low level and are concentrated in the absorbent for recovery, while the absorbent is regenerated by heating and subjecting it to vacuum in a separate hollow fiber membrane module called the stripping module.A pilot‐scale membrane‐based absorption‐stripping unit was located next to a paint spray booth at Robins Air Force Base, Warner Robins, GA. Tests were performed on slip‐streams of real‐time air emissions from scheduled intermittent painting operations, so the concentration of VOC in the exhaust air fluctuated with time. The VOC removal efficiency was determined as a function of the feed air flow rate and the absorbent (silicone oil) flow rate. Depending on the gas/liquid flow rates and the inlet VOC concentration, the process successfully removed as much as 95+% of the VOC present. The experimental results have been compared with theoretical predictions.