Abstract
In preparation for a Phase III comparison of high-dose versus standard-dose radiation therapy, this Phase I/II study was initiated to establish the maximum tolerated dose of radiation therapy in the setting of concurrent chemotherapy, using three-dimensional conformal radiation therapy for non-small-cell lung cancer. Eligibility included patients with histologically proven, unresectable Stages I to III non-small-cell lung cancer. Concurrent chemotherapy consisted of paclitaxel, 50 mg/m(2), and carboplatin, AUC of 2, given weekly. The radiation dose was to be sequentially intensified by increasing the daily fraction size, starting from 75.25 Gy/35 fractions. The Phase I portion of this study accrued 17 patients from 10 institutions and was closed in January 2004. After the initial 8 patients were accrued to cohort 1, the trial closed temporarily on September 26, 2002, due to reported toxicity. Two acute treatment-related dose-limiting toxicities (DLTs) were reported at the time: a case of grade 5 and grade 3 radiation pneumonitis. The protocol, therefore, was revised to de-escalate the radiation therapy dose (74 Gy/37 fractions). Patients in cohort 1 continued to develop toxicity, with 6/8 (75%) patients eventually developing grade >or=3 events. Cohort 2 accrued 9 patients. There was one DLT, a grade 3 esophagitis, in cohort 2 in the first 5 patients (1/5 patients) and no DLTs for the next 2 patients (0/2 patients). The maximum tolerated dose was determined to be 74 Gy/37 fractions (2.0 Gy per fraction) using three-dimensional conformal radiation therapy with concurrent paclitaxel and carboplatin therapy. This dose level in the Phase II portion has been well tolerated, with low rates of acute and late lung toxicities.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Radiation Oncology*Biology*Physics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.