A phase change material based annular thermoelectric energy harvester from ambient temperature fluctuations: Transient modeling and critical characteristics

Abstract

Annular thermoelectric power generator has been increasingly considered in application of ambient energy harvesting owing to the advantages of simple structure and no pollution. To improve thermal stability and energy harvesting performance of this system, the latent heat of phase change materials to improve thermal management and the high thermal conductivity of the heat sink to enhance heat transfer with the ambient are harness to annular thermoelectric power generator. Motivated by this, a phase change material based annular thermoelectric energy harvester (PCM-ATEH) with fins is developed for ambient energy harvesting and its three-dimensional transient model is also built up through jointly with thermo-electric and phase change processes. This paper considers the influence of key parameters such as temperature fluctuation amplitude, temperature fluctuation period, height ratio of PCM and thermoelectric generator (TEG) and melting temperature on liquid fraction, temperature difference, voltage and power density. Moreover, the comparison of PCM-ATEH and PCM based thermoelectric energy harvester (PCM-TEH) with/without fins is further conducted in this study to explore thermal management and energy harvesting performance. The energy harvesting characteristics of PCM-ATEH with fins is developed concerning the combination of power generation of TEG and melting process of PCM. Based on the results, it is found that the temperature difference and power density of PCM-ATEH with fins vary periodically with the sinusoidal temperature boundary, and results show that increasing temperature fluctuation period is not always feasible. Additionally, the comparative results indicate that the peak power density and energy efficiency of PCM-ATEH with fins are increased by 0.126 W/m2 and 0.02 % compared with PCM-TEH with fins, and increased by 0.195 W/m2 and 0.041 % compared with PCM-ATEH without fins. The results of energy harvesting characteristics show that a maximum of 0.77$ per watt can be reached to power generation cost of PCM-ATEH with fins. This paper can provide theoretical guidance for thermal management and energy conversion of energy harvesting system.