Abstract
A parametric study of the UV-A H2S photocatalytic oxidation over TiO2 P25 has investigated the influence of the TiO2 coating surface density, the total flow rate, the relative humidity, the temperature and the irradiance as main reaction parameters on the H2S conversion, the SO2 selectivity (targeted as low as possible), the duration without any SO2 release, and thus on the gas phase sulfur removal efficiency. The deepest non-illuminated internal TiO2 layers – even not photocatalytically active – could play a role in adsorbing SO2 and delaying its release into the gas phase, for explaining the behavior of high surface density TiO2 coatings. The Ti4+ surface sites have been proposed to act as active sites for the H2S photocatalytic oxidation, and general reaction pathways leading to the formation of SO2 in the gas phase and to surface sulfates have been hypothesized, involving photogenerated holes, sulfhydryl radicals or hydroxyl radicals. The role of active sulfate radicals has been put forward for explaining the behavior turn with time on stream on sulfate-deactivated TiO2, from a progressive deactivation into a complete H2S conversion to SO2. Finally, effective regeneration treatment with recovering of the initial activity could be performed by weakly basic washing.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.