Abstract
The current numerical study aims to examine the single and combined effects of various piston bowl geometries, diesel main Start of Injection (SOI) timing, and syngas energy ratio on the combustion characteristics, specific emissions (g/kW·h), energy distribution, and exergy of a heavy-duty off-road Reactivity-Controlled Compression Ignition (RCCI) diesel engine. The examined geometries include the stock chamber (baseline combustion chamber), wide-shallow chamber, dual-swirl chamber, stepped-lip chamber. The main SOI timing was varied from −20 to −5 Crank Angle (CA) After Top Dead Center (ATDC) with 5 CA steps. Also, syngas energy ratio including 0% Conventional Diesel Combustion (CDC) mode, 20%, 40%, and 60% of total fuel energy per cycle. To accomplish this goal, the SAGE combustion model coupled with a reduced chemical kinetic mechanism consists of 360 reactions, and 72 species was applied to conduct this investigation. The numerical findings showed that the use of the wide-shallow chamber extended the engine operable range under diesel-syngas combustion operating conditions. In comparison to the baseline CDC case, the application of the dual-swirl chamber under CDC conditions, and main SOI timing of −15 CA ATDC led to reduction of Carbon Monoxide ([Formula: see text]), Hydro-Carbon ([Formula: see text]), Particle Matter ([Formula: see text]), Carbon Dioxide ([Formula: see text]), Indicated Specific Energy Consumption (ISEC), Gross Indicated Efficiency (GIE), and exergy efficiency but with a Nitrogen Oxides ([Formula: see text]) penalty rate. In general, an increase in the bore to bowl diameter ratio caused a shorter ignition delay period and combustion duration. The utilization of the stepped-lip chamber at both CDC and diesel-syngas combustion operating modes resulted in a shorter ignition delay period, but a longer combustion duration. Nonetheless, the stepped-lip combustion chamber reduced the diffusive flame temperature. Also, it is noteworthy that the utilization of the stock chamber along with the main SOI timing at −5 CA ATDC under diesel-syngas 60% combustion mode is a suitable technique to pass EURO-VI [Formula: see text] and [Formula: see text] emissions regulations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.