Abstract

A numerical investigation of laminar natural convection heat transfer from small horizontal wires at near-critical pressures has been carried out with carbon dioxide as the test fluid. The parameters varied are: (i) Pressure (P): 7.50–9.60 MPa, (ii) Bulk fluid temperature (Tb): 5–50°C, (iii) Wall temperature (Tw): 5.1–200°C, and (iv) Wire diameter (D): 25.4, 76.2 and 100 μm. The steady-state Navier-Stokes equations (low Mach number asymptotic form) are solved with variable properties. The results of the numerical simulations agree reasonably well with available experimental data. The dependence of heat transfer coefficient (h) on P, Tb, Tw and D were investigated. The results obtained are as follows: (i) For given P and D, h is strongly dependent on Tb and Tw. (ii) The heat transfer coefficient decreases with increasing values of P (P/Pc > 1). (i) For fixed P, Tw and Tb, the dependence of h on D varies from h ∝ D−0.47 to h ∝ D−0.29 as D increases. (iii) For a given P, the maximum heat transfer coefficient is obtained for conditions where Tb < Tpc < Tw, where Tpc denotes the pseudocritical temperature. Based on the analysis of the temperature and flow field once can qualitatively show that this peak in h when k, Cp and Pr in the fluid peak close to the heated surface.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.