Abstract
In standard practice, testing of composites in tension requires the use of stress-inducing serrated grips. The low transverse compressive strength of unidirectional non-crimp fabric composites limits the application of high clamping forces. Tabs are therefore essential as they ensure a reduction in grip pressure transmission, surface damage and induced stress damage. Tabs, however, tend to introduce induced stress concentrations at the tab termination region. The objective of this study was to minimise stress concentration by varying tab design configurations to determine the optimal design most suitable for tensile testing of non-crimp fabric composites using finite element and statistical tools. Finite element models generated from experimental data were used for accessing the stress concentrations. A two (2)-level full factorial design was adopted and utilised for statistical analysis. Results revealed that tab stiffness, tab taper angle, adhesive thickness and manufacturing process (bonded or molded) were statistically significant for minimising stress concentration. Molded tabs were found to be acceptable if the stiffness of tab was significantly lower than test specimen.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
