A novel ZrB2-based composite manufactured with Ti3AlC2 additive

Abstract

A novel ZrB2–Ti3AlC2 composite was densified using spark plasma sintering at 1900 °C under pressure of 30 MPa for 7 min. The effect of Ti3AlC2 MAX phase on the densification behavior, microstructural evolutions, phase arrangement, and mechanical properties of the composite were investigated. The phase analysis and microstructural studies revealed the decomposition of the MAX phase at the initial steps of the SPS process. The structural characteristics and surface morphology of the in-situ synthesized reinforcements were verified using X-ray diffraction and scanning electron microscopy, respectively. The formation mechanism of each reinforcement phase was also investigated using thermodynamical assessments. The prepared ZrB2–Ti3AlC2 composite not only possessed a near fully-dense characteristic having an excellent hardness of 31 GPa, but also unexpectedly presented high fracture toughness. The indentation fracture toughness of the composite was calculated as 7.8 MPa m1/2, which is unprecedented compared with the same class of hard ZrB2-based composites. Indeed, the superior mechanical properties of the composite achieved in this study was obtained by the homogenous distribution of Al-based reinforcements, formation of hard interfacial ZrC grains, and solid solutions provided by Ti-based phases. The correlations between the phase arrangement, microstructure, and the attained mechanical properties of the composite were comprehensively discussed.